Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Yardım
Adım 5 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Ideally we would disconnect the battery first. Unfortunately, the battery wires are soldered to the board underneath the RF shield. The first step is to remove the shield. It is soldered onto the main board in 4 places, circled in red.

Using a low-heat, fine-tip soldering iron, carefully heat up the pads and lift the shield off the board. Be very careful not to splatter or spread any solder on the board itself.

The shield wraps around the LCD connector (upper left), but is only tucked in. It may be carefully pulled out, then placed aside.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.