Ana içeriğe geç
Adım 1 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Remove the white tape from either end of the rear of the CCFL assembly.

Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you DO NOT cut or nick the wire insulation.

The wires have a HIGH VOLTAGE applied during operation and the insulation may break down if damaged causing a short

While holding the assembly, slowly and gently pull the THICK wires up and out of the slots in the white rubber cap.

Pull the wires one at a time ensuring you don't flex the CCFL and break it.

This will reveal the pins and solder joints.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.