Ana içeriğe geç
Adım 3 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Firstly the power and Sata cables should be disconected - they can be removed by just pulling them straight back.

After this is done it should look like the second picture.

Lastly four screws need to be removed that secure the Hard Drive to the case.

Extreme care should be take here as the Hard Drive should be supported when loosening off the last screw. Be careful not to press on the casing and only hold it by the edges.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.