Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Yardım
Adım 6 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Re-insert the two 10 mm bolts and tighten them until they are snug by turning them clockwise with a box end wrench or socket wrench.

If the bolts cannot reach their holes because the strut mounts are not close enough to the lower control arm, ensure that the strut is through the hole mentioned in the previous step. If it is, you will need to push the strut up and hold it until you can partially thread the bolts.

The factory torque specification for these bolts is 21 ft-lbf or 28N-m.

Thread the bolts in even, alternating increments to reduce stress on the components.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.