Ana içeriğe geç
Yardım

Removing iPad 3 4G Front Panel

Adım 20 Düzenleniyor —

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 153kılavuzları etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Slide the opening pick along the left edge of the iPad, releasing the adhesive as you go. The adhesive is thin here due to the digitizer along the whole left side. Make sure the pick is not too deep (max 1/2 inch) 10 mm to prevent damaging the digitizer.

The digitizer cable is located approximately 2" (50 mm) from the bottom of the iPad. Stop sliding the pick when you get ~2.25" (60 mm) from the bottom of the iPad.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.