Giriş

Install an original Airport 802.11b card internally.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

    Yorum Ekle

  2. Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    Yorum Ekle

    • If your computer does not have an Airport card installed, skip to the RAM shield removal step.

    • Push the wire clasp toward the Airport card and pull it up to free it from the RAM shield.

    Yorum Ekle

    • Grasp the clear plastic tab on the Airport card and pull toward the right.

    Yorum Ekle

    • Hold the Airport card in one hand and use your other hand to remove the antenna cable.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 başka kişi bu kılavuzu tamamladı.

Ekli Belgeler

iRobot

Üyelik tarihi: 24-09-2009

1 İtibar

621 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 1

Her zaman: 7,534