Eşyalarını Tamir Et Topluluğa Katılın Mağaza

iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement

Giriş

Replacing this keyboard is easy and takes only a few minutes.

What you need

  1. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement, Battery: adım 1, 1 resimden 1.

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    Düzenle

  2. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 2, 1 resimden 1.

    • Lift the battery out of the computer.

    Düzenle

  3. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement, Keyboard: adım 3, 1 resimden 1.

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    Düzenle

  5. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 4, 1 resimden 1.

    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

    Düzenle

  6. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 5, 1 resimden 1.

    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

    Düzenle

  7. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 6, 1 resimden 1.

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    Düzenle

  8. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 7, 1 resimden 1.

    • Remove the four silver Phillips screws that secure the RAM shield.

    Düzenle

  9. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 8, 1 resimden 1.

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    Düzenle

  10. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: adım 9, 1 resimden 1.

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

12 farklı kişi bu kılavuzu tamamladı.

Yazar

5 tane daha katılımcı ile

iRobot

Üyelik tarihi: 09/24/09

1 İtibar

636 adet Kılavuz yazıldı

Badges: 36

+33 tane daha rozet

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 10

Her zaman: 16,019