Eşyalarını Tamir Et Topluluk Mağaza

iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Giriş

This guide is an internal private guide that serves as a prereq.

Neye ihtiyacın var

  1. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement, LCD Cover: adım 1, 1 resimden 1.

    • Remove the large piece of tape near the lower right corner of the display.

    Düzenle

  2. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 2, 2 resimden 1. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 2, 2 resimden 2.

    • Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws).

    • Use the tip of a spudger to remove the small washer under the screw you just removed.

    Düzenle

  3. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 3, 1 resimden 1.

    • Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.

    • It is not necessary to peel the tape off the thin steel LCD cover.

    Düzenle

  5. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 4, 1 resimden 1.

    • Remove the pieces of readily removable tape from around the perimeter of the display.

    Düzenle

  6. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 5, 2 resimden 1. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 5, 2 resimden 2.

    • Remove the piece of aluminum tape near the center of the LCD cover.

    • Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.

    Düzenle

  7. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 6, 2 resimden 1. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 6, 2 resimden 2.

    • Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

    Düzenle

  8. iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement: adım 7, 1 resimden 1.

    • Lift the thin steel LCD cover off the LCD.

    Düzenle

    All the RF shields are aluminum, and the frame is cast magnesium, fwiw.

    Theron Ninth - Yanıt

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 512