Giriş

Replacing this keyboard is easy and takes only a few minutes.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

Yorum Ekle

Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.
  • Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (shown in orange) 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Yorum Ekle

  • Loosen the four silver Phillips screws that secure the RAM shield.

  • These screws will not come out all the way. The screws are held captive to the RAM shield to prevent them from getting lost.

Yorum Ekle

  • Remove the RAM shield from the computer.

  • The four captive screws will come out with the RAM shield.

Yorum Ekle

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

  • When reassembling your iBook, make sure that you reconnect the keyboard cable before replacing the RAM shield.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

8 başka kişi bu kılavuzu tamamladı.

Ekli Belgeler

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 10

Son 30 Gün: 37

Her zaman: 11,113