Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement

Neye ihtiyacın var

  1. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Battery: adım 1, 1 resimden 1.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 2, 1 resimden 1.
    • Lift the battery out of the computer.

  3. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Keyboard: adım 3, 1 resimden 1.
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

  4. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 4, 1 resimden 1.
    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

  5. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 5, 1 resimden 1.
    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

  6. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 6, 1 resimden 1.
    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

  7. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 7, 1 resimden 1.
    • Remove the four silver Phillips screws that secure the RAM shield.

  8. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 8, 1 resimden 1.
    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

  9. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: adım 9, 1 resimden 1.
    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 farklı kişi bu kılavuzu tamamladı.

iRobot

Üyelik tarihi: 09/24/09

1 İtibar

636 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 2

Son 30 gün: 5

Her zaman: 12,221