Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement

Yazan: Justin (ve 7 başka katılımcı)
  • Yorumlar: 1
  • Favoriler: 3
  • Tamamlanma: 6

Zorluk

Çok kolay

Adımlar

5

Gerekli Süre

Bir süre öner??

Bölümler

2

İşaretler

0

Giriş

Remove bottom housing to reveal the inside of the iMac.

Aletler

Bu aletleri satın al

Parçalar

Hiçbir parça belirtilmedi.

  1. Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

    • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

    Düzenle

  2. Loosen the four Phillips #0 screws.

    • Loosen the four Phillips #0 screws.

    Düzenle

  3. Nintendo Switch Setleri

    A quick fix to get back in the game

    Shop Switch Kits

    Nintendo Switch Setleri

    A quick fix to get back in the game

    Shop Switch Kits

  4. Carefully remove the base access panel.

    • Carefully remove the base access panel.

    Düzenle

  5. Remove the four 25mm T-15 screws. Remove the four 25mm T-15 screws.

    • Remove the four 25mm T-15 screws.

    Düzenle

  6. Open the housing plate. Be gentle with the wires still connected to the logic board so as not to ruin the cables.

    • Open the housing plate.

    • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

    • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

6 farklı kişi bu kılavuzu tamamladı.

Yazar

7 tane daha katılımcı ile

Justin

Üyelik tarihi: 05-10-2011

250 İtibar

3 adet Kılavuz yazıldı

Rozetler: 10

+7 tane daha rozet

Takım

Cal Poly, Team 21-22, Maness Fall 2011 Cal Poly, Team 21-22, Maness Fall 2011 üyesi

CPSU-MANESS-F11S21G22

4 Üyeler

13 adet Kılavuz yazıldı

Bir Yorum

Yorum Ekle

If you do this - don't you still need to apply a fresh coat of thermal paste to the exposed ends of the two heat-sink posts (that separate when you open a G4 flatpanel this far) - my understanding was that the machine would overheat and you'd be left with didley squat!!

Gregg :O)

amicuset - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 6

Her zaman: 1,705