Giriş

Remove the access door to replace RAM chips.

Parçalar

Hiçbir parçaya gerek yok.

Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.
  • Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.

  • These screws will remain captive in the access door.

  • Remove the access door from your iMac.

  • During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.

In order for the logic board to come out cleanly, one should remove the RAM at the end of this step.

kevmacmills - Yanıt

Definitely! The author should make this as a step in the description (because not everyone reads Comments)

finnik2d - Yanıt

Just did this procedure and the RAM must absolutely come out for the logic board to come free later.

matt - Yanıt

Sonuç

To reassemble your device, follow these instructions in reverse order.

5 başka kişi bu kılavuzu tamamladı.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 4

Son 30 Gün: 19

Her zaman: 7,922