Ana içeriğe geç

Giriş

Prereq only.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the two 9 mm T10 Torx screws securing the upper hard drive bracket to the outer case.
    • Remove the two 9 mm T10 Torx screws securing the upper hard drive bracket to the outer case.

  2. Slightly rotate the hard drive out of the outer case and lift it up off its mounting pins toward the top edge of the iMac.
    • Slightly rotate the hard drive out of the outer case and lift it up off its mounting pins toward the top edge of the iMac.

    • Be careful not to contact the AirPort card as you lift the hard drive out of its recess.

  3. Disconnect the SATA data cable and SATA power connector from their respective sockets by pulling each connector away from the hard drive. Disconnect the SATA data cable and SATA power connector from their respective sockets by pulling each connector away from the hard drive.
    • Disconnect the SATA data cable and SATA power connector from their respective sockets by pulling each connector away from the hard drive.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 319