Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

Internal Prereq.

  1. Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself. Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.
    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

  2. Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.
    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

  3. Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel. Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.
    • Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.

  4. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Hemen Alışveriş Yapın

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Hemen Alışveriş Yapın
  5. Pull the headphone jack away from the top edge of the iPad.
    • Pull the headphone jack away from the top edge of the iPad.

    • Don't try to remove the assembly just yet. The front camera is still stuck to the rear panel.

  6. Lift the headphone jack & front camera cables slightly to access the microphone connector.
    • Lift the headphone jack & front camera cables slightly to access the microphone connector.

    • Use the edge of a plastic opening tool to separate the microphone connector from its socket on the headphone jack & front camera cables.

  7. Peel the front camera off the foam adhesive securing it to the rear panel. Remove the headphone jack & front camera assembly from the iPad.
    • Peel the front camera off the foam adhesive securing it to the rear panel.

    • Remove the headphone jack & front camera assembly from the iPad.

  8. Carefully remove the strip of tape covering the front camera cable connector.
    • Carefully remove the strip of tape covering the front camera cable connector.

  9. Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.
    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 487