Bu sürüm, hatalı düzenlemeler içerebilir. En son doğrulanmış bellek kopyası dönün.
Neye ihtiyacın var
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.
-
Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.
-
Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.
-
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Pull the headphone jack away from the top edge of the iPad.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Lift the headphone jack & front camera cables slightly to access the microphone connector.
-
Use the edge of a plastic opening tool to separate the microphone connector from its socket on the headphone jack & front camera cables.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Peel the front camera off the foam adhesive securing it to the rear panel.
-
Remove the headphone jack & front camera assembly from the iPad.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Carefully remove the strip of tape covering the front camera cable connector.
-
-
Bu adım çevrilmemiş. Çevrilmesine yardım edin
-
Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.
-