Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

iPad 6 Wi-Fi Front Panel Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. iPad 6 Wi-Fi Front Panel Assembly Replacement, Front Panel Assembly: adım 1, 2 resimden 1. iPad 6 Wi-Fi Front Panel Assembly Replacement, Front Panel Assembly: adım 1, 2 resimden 2.
    • Remove any tape covering the home button ribbon cable connector.

  2. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 2, 3 resimden 1. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 2, 3 resimden 2. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 2, 3 resimden 3.
    • Use the flat end of a spudger to flip the tab on the home button ribbon cable ZIF connector upward.

    • Carefully pull the home button ribbon cable straight out of the ZIF connector.

  3. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 3, 3 resimden 1. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 3, 3 resimden 2. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 3, 3 resimden 3.
    • Use a the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets.

    • To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.

  4. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 4, 2 resimden 1. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 4, 2 resimden 2.
    • Carefully peel the home button ribbon cable up off of the adhesive holding it to the rear case.

  5. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 5, 2 resimden 1. iPad 6 Wi-Fi Front Panel Assembly Replacement: adım 5, 2 resimden 2.
    Bu adımda kullanılan alet:
    Polyimide Tape
    $9.99
    Satın Al
    • Remove the front panel assembly.

    • If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide) tape, to the highlighted areas on the back of the panel. iFixit panels come with the proper insulation, and should not require the addition of any tape.

    • Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.

    • The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Sam Goldheart

Üyelik tarihi: 10/18/12

465.278 İtibar

538 adet Kılavuz yazıldı

Ekip

iFixit iFixit üyesi

Staff

136 Üyeler

16.573 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 132