Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

prereq for everything upper case

  1. Remove the following screws securing the upper component cable bracket:
    • Remove the following screws securing the upper component cable bracket:

    • Two 2.0 mm Phillips screws

    • Three 1.4 mm Phillips screws

  2. Use tweezers to start peeling back the tape securing the upper component cable bracket. Use tweezers to start peeling back the tape securing the upper component cable bracket.
    • Use tweezers to start peeling back the tape securing the upper component cable bracket.

  3. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.
    • Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Üyelik tarihi: 17-10-2009

434.094 İtibar

411 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

108 Üyeler

9.975 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 36