Ana içeriğe geç

Giriş

Prerequisite guide for disconnecting the battery before performing any repair.

Parçalar

Hiçbir parça belirtilmedi.

  1. To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.
    • To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.

    • Remove the four 1.2 mm Phillips screws over the battery/display connector bracket.

  2. Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın
  3. Remove the battery/display cable bracket.
    • Remove the battery/display cable bracket.

  4. When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board. Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.
    • When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board.

    • Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.

    • Bend the battery connector ribbon cable up slightly to prevent it from making contact and powering on the iPad.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

Üyelik tarihi: 05-02-2015

178.101 İtibar

177 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

108 Üyeler

9.435 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

Her zaman: 77