Ana içeriğe geç

Giriş

Prerequisite to remove the speaker after the logic board.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the following screws:
    • Remove the following screws:

    • One 2.9 mm Phillips #000 screw

    • One 1.5 mm Phillips #000 screw

    • One 3.6 mm Phillips #000 screw

  2. Use the flat end of a spudger to gently lift the speaker from the rear case. Do not attempt to pry the speaker entirely out of the case.
    • Use the flat end of a spudger to gently lift the speaker from the rear case.

    • Do not attempt to pry the speaker entirely out of the case.

  3. The speaker has a small peg that slides into a slot beneath the home button cable socket. Lift the speaker and pull it toward the side of the phone to free this peg from the Lightning connector assembly. Remove the speaker.
    • The speaker has a small peg that slides into a slot beneath the home button cable socket.

    • Lift the speaker and pull it toward the side of the phone to free this peg from the Lightning connector assembly.

    • Remove the speaker.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Üyelik tarihi: 18-10-2012

444.280 İtibar

547 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

139 Üyeler

15.648 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 628