Ana içeriğe geç

iPhone 6 Plus Lightning Connector Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. iPhone 6 Plus Lightning Connector Assembly Replacement, Lightning Connector Assembly: adım 1, 1 resimden 1.
    • Remove the two 3.3 mm Phillips #00 screws securing the metal bracket to the Lightning connector assembly.

  2. iPhone 6 Plus Lightning Connector Assembly Replacement: adım 2, 1 resimden 1.
    • Use a pair of tweezers to lift and remove the metal bracket out of the iPhone.

  3. iPhone 6 Plus Lightning Connector Assembly Replacement: adım 3, 1 resimden 1.
    • Use the flat edge of a spudger to pry the antenna connector cable up off its socket on the Lightning connector assembly.

  4. iPhone 6 Plus Lightning Connector Assembly Replacement: adım 4, 1 resimden 1.
    • Lift and remove the antenna connector out of the iPhone.

  5. iPhone 6 Plus Lightning Connector Assembly Replacement: adım 5, 1 resimden 1.
    • Remove the following Phillips #00 screws securing the Lightning connector assembly to the rear case:

    • Two 3.2 mm screws

    • One 3.8 mm screw

    • Two 1.7 mm screws

    • Two 1.5 mm screws

    • Two 1.4 mm screws

  6. iPhone 6 Plus Lightning Connector Assembly Replacement: adım 6, 1 resimden 1.
    • Use a pair of tweezers to grasp the plastic clip that is situated to the right of the headphone jack and remove it from the iPhone.

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 farklı kişi bu kılavuzu tamamladı.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 1,812