Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

iPhone 6s Plus Speaker Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. iPhone 6s Plus Speaker Replacement, Speaker: adım 1, 2 resimden 1. iPhone 6s Plus Speaker Replacement, Speaker: adım 1, 2 resimden 2.
    • Use the point of a spudger to pry up and disconnect the antenna cable from the bottom of the logic board.

  2. iPhone 6s Plus Speaker Replacement: adım 2, 2 resimden 1. iPhone 6s Plus Speaker Replacement: adım 2, 2 resimden 2.
    • Use the point of a spudger to pry up and disconnect the Lightning connector cable from the logic board.

  3. iPhone 6s Plus Speaker Replacement: adım 3, 2 resimden 1. iPhone 6s Plus Speaker Replacement: adım 3, 2 resimden 2.
    • Remove the three Phillips screws securing the Lightning connector bracket:

    • Two 3.5 mm screws

    • One 2.7 mm screw

    • Remove the bracket.

  4. iPhone 6s Plus Speaker Replacement: adım 4, 2 resimden 1. iPhone 6s Plus Speaker Replacement: adım 4, 2 resimden 2.
    • Use the point of a spudger to pry up and disconnect the antenna cable from the Lightning connector assembly.

  5. iPhone 6s Plus Speaker Replacement: adım 5, 2 resimden 1. iPhone 6s Plus Speaker Replacement: adım 5, 2 resimden 2.
    • Use the point of a spudger to pry up and disconnect the antenna cable from the top of the logic board.

  6. iPhone 6s Plus Speaker Replacement: adım 6, 3 resimden 1. iPhone 6s Plus Speaker Replacement: adım 6, 3 resimden 2. iPhone 6s Plus Speaker Replacement: adım 6, 3 resimden 3.
    • Carefully lift the antenna cable and de-route it from the edge of the phone. Use the point of a spudger to help lift the cable free it from the retaining clips.

    • If the cable does not have enough room to lift up, loosen this Phillips screw securing the logic board so that the board can give more wiggle room.

    • Be sure to re-tighten this screw during re-installation.

    • During re-installation, be sure to route the antenna cable underneath the logic board corner.

    • During re-installation, you can also re-insert the SIM card tray after re-routing the antenna cable.

    • If you feel any resistance, stop and make sure that the tray isn't snagging the antenna cable.

  7. iPhone 6s Plus Speaker Replacement: adım 7, 2 resimden 1. iPhone 6s Plus Speaker Replacement: adım 7, 2 resimden 2.
    • Remove the six Phillips screws securing the speaker to the rear case:

    • One 2.5 mm screw

    • Two 2.7 mm screws

    • One 1.5 mm screw

    • One 1.7 mm screw

    • One 2.6 mm screw securing the speaker to the bottom edge of the rear case.

  8. iPhone 6s Plus Speaker Replacement: adım 8, 3 resimden 1. iPhone 6s Plus Speaker Replacement: adım 8, 3 resimden 2. iPhone 6s Plus Speaker Replacement: adım 8, 3 resimden 3.
    • Insert the flat end of a spudger between the long edge of the speaker module and the case wall.

    • Pry gently to loosen the speaker module.

    • Once the module is loose, lift and remove the speaker module and the attached antenna cable from the phone.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Arthur Shi

Üyelik tarihi: 01/03/18

248.412 İtibar

503 adet Kılavuz yazıldı

Ekip

iFixit iFixit üyesi

Staff

136 Üyeler

16.562 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 150