Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

prereq only

  1. Use the flat end of a spudger to disconnect the rear-facing camera connector. Use the flat end of a spudger to disconnect the rear-facing camera connector.
    • Use the flat end of a spudger to disconnect the rear-facing camera connector.

  2. Remove the following Phillips screws securing the rear camera bracket to the rear case: One 1.3 mm screw
    • Remove the following Phillips screws securing the rear camera bracket to the rear case:

    • One 1.3 mm screw

    • One 2.5 mm screw

  3. Remove the bracket.
    • Remove the bracket.

  4. Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module. Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module.
    • Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module.

  5. Remove the two 1.2 mm tri-point screws securing the upper cable bracket.
    • Remove the two 1.2 mm tri-point screws securing the upper cable bracket.

  6. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits
  7. Remove the upper cable bracket. Remove the upper cable bracket.
    • Remove the upper cable bracket.

  8. Use the flat end of a spudger to disconnect the upper cable connector. Use the flat end of a spudger to disconnect the upper cable connector.
    • Use the flat end of a spudger to disconnect the upper cable connector.

  9. Remove the Phillips screws securing the Wi-Fi antenna: Three 1.2 mm screws
    • Remove the Phillips screws securing the Wi-Fi antenna:

    • Three 1.2 mm screws

    • One 1.7 mm screw

  10. Remove the top left antenna. Remove the top left antenna.
    • Remove the top left antenna.

  11. Remove the following Phillips screws:
    • Remove the following Phillips screws:

    • One 1.3 mm screw

    • One 2.2 mm screw

  12. Remove the bracket. Remove the bracket.
    • Remove the bracket.

  13. Remove the 2.2 mm standoff screw from the grounding bracket.
    • Remove the 2.2 mm standoff screw from the grounding bracket.

    • Standoff screws are best removed using an [bağlı ürün eksik veya kapalı: IF145-343-1] and driver handle.

    • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  14. Use tweezers to gently bend the logic board grounding bracket out of the way. Use tweezers to gently bend the logic board grounding bracket out of the way.
    • Use tweezers to gently bend the logic board grounding bracket out of the way.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

Üyelik tarihi: 05-02-2015

196.698 İtibar

178 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

128 Üyeler

13.120 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 2

Her zaman: 103