Ana içeriğe geç

Giriş

prerequisite

  1. Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.

  2. Remove the following screws securing the headphone jack, Lightning connector, and speaker.
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. Use the flat end of a spudger to pry the speaker up from the rear case.
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Üyelik tarihi: 17-10-2009

429.950 İtibar

411 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

107 Üyeler

9.591 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 130