Ana içeriğe geç

iPod Touch 5th Generation Lightning Connector Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. iPod Touch 5th Generation Lightning Connector Assembly Replacement, Lightning Connector Assembly: adım 1, 1 resimden 1.
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.

  2. iPod Touch 5th Generation Lightning Connector Assembly Replacement: adım 2, 1 resimden 1.
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. iPod Touch 5th Generation Lightning Connector Assembly Replacement: adım 3, 1 resimden 1.
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. iPod Touch 5th Generation Lightning Connector Assembly Replacement: adım 4, 2 resimden 1. iPod Touch 5th Generation Lightning Connector Assembly Replacement: adım 4, 2 resimden 2.
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Üyelik tarihi: 10/17/09

502.275 İtibar

407 adet Kılavuz yazıldı

Ekip

iFixit iFixit üyesi

Staff

136 Üyeler

16.561 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 225