Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

The front shell of the iRobot Braava Jet 240 covers all of the device’s circuitry as well as the nozzle. Therefore, to replace the nozzle, the front shell must first be removed. Follow this guide to remove the front shell.

Parçalar

Hiçbir parça belirtilmedi.

  1. Turn the device off.
    • Turn the device off.

  2. Use your fingers to gently pop out the battery. Use your fingers to gently pop out the battery.
    • Use your fingers to gently pop out the battery.

  3. Lift up the handle to reveal the eject button. Lift up the handle to reveal the eject button.
    • Lift up the handle to reveal the eject button.

  4. Nintendo Switch Kit'leri

    Oyuna geri dönmek için hızlı bir düzeltme

    Switch Kit'leri Satın Al

    Nintendo Switch Kit'leri

    Oyuna geri dönmek için hızlı bir düzeltme

    Switch Kit'leri Satın Al
  5. Use your finger to push the eject button forward. Use your finger to push the eject button forward. Use your finger to push the eject button forward.
    • Use your finger to push the eject button forward.

  6. Tilt the robot on its side and let the mop pad slide out.
    • Tilt the robot on its side and let the mop pad slide out.

  7. Remove the two 22.0  mm screws on the bottom-front of the robot using a Phillips #1 screwdriver. Remove the two 22.0  mm screws on the bottom-front of the robot using a Phillips #1 screwdriver.
    • Remove the two 22.0 mm screws on the bottom-front of the robot using a Phillips #1 screwdriver.

  8. Use a Phillips #1 screwdriver and an iFixit opening tool to remove the two 15.0 mm screws on the front sides of the robot. Use a Phillips #1 screwdriver and an iFixit opening tool to remove the two 15.0 mm screws on the front sides of the robot.
    • Use a Phillips #1 screwdriver and an iFixit opening tool to remove the two 15.0 mm screws on the front sides of the robot.

  9. Carefully pull back on the front shell to remove it from the robot. Carefully pull back on the front shell to remove it from the robot. Carefully pull back on the front shell to remove it from the robot.
    • Carefully pull back on the front shell to remove it from the robot.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Claire Franz

Üyelik tarihi: 10-02-2020

819 İtibar

7 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

125 Üyeler

11.822 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 9

Her zaman: 94