Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

If the wheels on your iRobot Braava Jet 240 need to be replaced, follow this guide.

The wheels of the iRobot Braava Jet 240 are connected to the motor assembly and allow the robot to move around the room to clean. If there is debris caught in the wheels, removing them to clean out debris will be useful. Additionally, if the tire tread is loose or the wheels are otherwise damaged, they should be removed and replaced.

Parçalar

Hiçbir parça belirtilmedi.

  1. Turn the device off.
    • Turn the device off.

  2. Use your fingers to gently pop out the battery. Use your fingers to gently pop out the battery.
    • Use your fingers to gently pop out the battery.

  3. Lift up the handle to reveal the eject button. Lift up the handle to reveal the eject button.
    • Lift up the handle to reveal the eject button.

  4. Nintendo Switch Kit'leri

    Oyuna geri dönmek için hızlı bir düzeltme

    Switch Kit'leri Satın Al

    Nintendo Switch Kit'leri

    Oyuna geri dönmek için hızlı bir düzeltme

    Switch Kit'leri Satın Al
  5. Use your finger to push the eject button forward. Use your finger to push the eject button forward. Use your finger to push the eject button forward.
    • Use your finger to push the eject button forward.

  6. Tilt the robot on its side and let the mop pad slide out.
    • Tilt the robot on its side and let the mop pad slide out.

  7. Using your thumbs, first push back the motor assembly, then push up. Using your thumbs, first push back the motor assembly, then push up.
    • Using your thumbs, first push back the motor assembly, then push up.

  8. Remove the 11.55 mm screws in the middle of both wheels using the Phillips #1 screwdriver. Remove the 11.55 mm screws in the middle of both wheels using the Phillips #1 screwdriver.
    • Remove the 11.55 mm screws in the middle of both wheels using the Phillips #1 screwdriver.

  9. Pull the wheel off from the axel, pulling from the top end first so it can slide out at an angle. It will be easier to remove the wheels if the motor assembly is tilted so that the wheel that you are removing is elevated. It will be easier to remove the wheels if the motor assembly is tilted so that the wheel that you are removing is elevated.
    • Pull the wheel off from the axel, pulling from the top end first so it can slide out at an angle.

    • It will be easier to remove the wheels if the motor assembly is tilted so that the wheel that you are removing is elevated.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Claire Franz

Üyelik tarihi: 10-02-2020

819 İtibar

7 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

125 Üyeler

11.822 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 7

Son 7 gün: 36

Son 30 gün: 165

Her zaman: 453