Giriş

This is an easy guide. It should only take a few minutes to complete. The only tool required is Phillips #1 Screwdriver.

Parçalar

Hiçbir parçaya gerek yok.

Lay the Roomba upside down on a flat surface. The edge brush is located near the battery pack.
  • Lay the Roomba upside down on a flat surface.

  • The edge brush is located near the battery pack.

Yorum Ekle

Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.
  • Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.

Yorum Ekle

Grab the edge brush and lift it up to remove.
  • Grab the edge brush and lift it up to remove.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Samantha Barrett

Üyelik tarihi: 13-01-2014

501 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 17-5, Forte Winter 2014 Cal Poly, Team 17-5, Forte Winter 2014 üyesi

CPSU-FORTE-W14S17G5

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Tüm Zamanlar: 301