Giriş

This guide explains how to remove the brush case from your Roomba.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

    If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

    David Forrest - Yanıt

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

    Yorum Ekle

    • Gently pull upwards on the brush to remove it.

    Yorum Ekle

    • Rotate the Roomba upside-down so the bottom is facing towards you.

    Yorum Ekle

    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

    Yorum Ekle

    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

    Yorum Ekle

    • Push on the dirt bin release button, and pull gently.

    Might as well do this first, so you don’t dump dirt everywhere when flipping Roomba over.

    maccentric - Yanıt

    • Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .

    Yorum Ekle

    • Grab the brush case and pull upwards to remove.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

John McTigue

Üyelik tarihi: 31-01-2014

331 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014 üyesi

CPSU-REGAN-W14S13G14

4 Üyeler

13 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 3

Her zaman: 485