Ana içeriğe geç

Giriş

This motor is what keeps that yellow side brush turning, picking up hairs and things dust in those hard to reach places.

Parçalar

Hiçbir parça belirtilmedi.

  1. First start by removing the two - 6mm screws with your Phillips head #1, that unlock the motor from your Roomba Pull the brush motor out Pull the brush motor out
    • First start by removing the two - 6mm screws with your Phillips head #1, that unlock the motor from your Roomba

    • Pull the brush motor out

  2. Next, with the same head remove the screw holding the plastic housing together Carefully pry the gear box open by placing a flat head screwdriver in the slot This might be difficult and require some shifting of the screwdriver
    • Next, with the same head remove the screw holding the plastic housing together

    • Carefully pry the gear box open by placing a flat head screwdriver in the slot

    • This might be difficult and require some shifting of the screwdriver

  3. Removing these two screws will allow you to access the motor (use the same head as before) Removing these two screws will allow you to access the motor (use the same head as before) Removing these two screws will allow you to access the motor (use the same head as before)
    • Removing these two screws will allow you to access the motor (use the same head as before)

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Matt Davis

Üyelik tarihi: 22-01-2015

1.294 İtibar

7 adet Kılavuz yazıldı

Takım

Cal Poly, Team 21-20, Maness Winter 2015 Cal Poly, Team 21-20, Maness Winter 2015 üyesi

CPSU-MANESS-W15S21G20

4 Üyeler

14 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 17

Her zaman: 994