Eşyalarını Tamir Et Topluluk Mağaza
Yardım

Depth Sensor Node Enclosure Assembly

Tahmini Süre

  • 1 × Soldering Iron
  • 1 × Lead-Free Solder
  • 1 × Phillips #3 Screwdriver
  • 1 × Heat Shrink Tubing Assortment
  • 1 × Heat Shrink Gun
  • 1 × Flush Cutter
  • 1 × Wire Stripper
  • 1 × 6-in-1 Screwdriver
  • 1 × Large Needle Nose Pliers
  • 1 × PSOC Programmer
  • 1 × USB to TTL Serial Converter
  • 1 × Voltmeter
  • 1 × USB Power Supply
  • 1 × Enclosure
  • 1 × Depth Sensor
  • 1 × Microcontroller board
  • 1 × Twilio Cellular Modem
  • 1 × Solar Panel
  • 1 × Solar Panel Frame
  • 1 × 3.7V Lithium Ion Battery
  • 1 × Antenna
  • 2 × Jumper pins
  • 4 × Solar Panel Nuts -
  • 4 × Solar Panel Screws
  • 1 × Waterproof Cable Gland Connector
  • 1 × GPS
  • 8 × Standoffs
  • 1 × SuperSIM
  • 1 × Lock
  • 1 × Battery
  • 1 × Foam for Securing Battery
  • 2 × Cable Ties (Battery & Solar Panel)
  • 1 × Solar Panel Extension Wire
  • 1 × Worm-Drive Clamp for Firm Hose and Tube 316 Stainless Steel, 5/16" Band Width, 7/32"- 5/8" Clamp ID Range
  • 1 × Node ID Sticker
  • 1 × Enclosure to Board screws
  • 1 × 8GB MicroSD Card
  • 1 × Depth Sensor MB7950 Mounting Hardware
  • 1 × Black, red, white wire
  • 1 × Moisture-Seal Heat-Shrink Tubing 2:1 0.25" diameter heat shrink tubing (4 ft)
  • 1 × Moisture-Seal Heat-Shrink Tubing 2:1 Shrink Ratio, 0.19" ID Before Shrinking, 4 Feet Long
  • 1 × TERM BLK 3P SIDE ENT 2.54MM PCB
  • 1 × 5-Wire Terminal Block Plug (3.5 mm)
  • 1 × 2-Wire Terminal Block Plug (3.5 mm)
Yeni Ekle

Öne Çıkarılan

Kılavuza gömmek için bir PDF'i ön plana çıkarın.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.