Giriş

The guide takes place from the Camera Lens Assembly guide.

Parçalar

Hiçbir parçaya gerek yok.

  1. Locate the memory card and battery card latch on the bottom of the camera.
    • Locate the memory card and battery card latch on the bottom of the camera.

    • Slide the latch to the open position.

    Yorum Ekle

  2. Open the battery latch, and slide the battery release lever to the right.
    • Open the battery latch, and slide the battery release lever to the right.

    Yorum Ekle

    • Remove the battery from the camera.

    Yorum Ekle

    • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Use this screwdriver for all screws in the device.

    Yorum Ekle

    • Remove the 3.15 mm screw on the left side of the camera.

    Yorum Ekle

    • Remove the left side casing.

    Yorum Ekle

    • Remove the two 3.15 mm screws on the right side of the camera.

    Yorum Ekle

    • Remove the bottom right panel.

    Yorum Ekle

    • Gently remove the back casing.

    • Start at the bottom and carefully pry towards the top to get this piece free.

    Yorum Ekle

    • Remove the two black 5.35 mm screws that hold in the front faceplate.

    • There may be a third screw the the right of the lens assembly.

    Yorum Ekle

    • Carefully remove the upper assembly, which houses the buttons and the flash battery.

    Yorum Ekle

    • Carefully remove the front casing after verifying that the thin plastic around the lens is not still attached.

    Yorum Ekle

    • Remove the three black 5mm screws attached to the lens frame.

    Yorum Ekle

    • Remove the lens frame.

    Yorum Ekle

    • Lift out the circuit board as shown.

    Yorum Ekle

    • Lift the two black latches that hold the connector ribbons in place.

    • Disconnect the two ribbons.

    Yorum Ekle

    • Remove the lens assembly as shown.

    Yorum Ekle

    • Remove four 4mm screws from the lens assembly.

    Yorum Ekle

    • Carefully turn over the assembly.

    Yorum Ekle

    • Remove the Fixed Frame Unit by separating it from the assembly.

    • Remove the Direct Frame Unit from the assembly.

    Yorum Ekle

    • Remove the 1st lens frame from the lens assembly.

    Yorum Ekle

    • Detach the 2nd Frame Unit from the assembly.

    Yorum Ekle

    • Remove the 4mm screw from the lens housing.

    Yorum Ekle

    • Separate the lens housing.

    • Replace the lens by gently prying away from the assembly.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 başka kişi bu kılavuzu tamamladı.

Caleb Fink

Üyelik tarihi: 11-10-2010

186 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-22, Regan Fall 2010 Cal Poly, Team 9-22, Regan Fall 2010 üyesi

CPSU-REGAN-F10S9G22

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 12

Her zaman: 11,906