Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 5 kılavuzları etkileyecektir.

İngilizce
Japonca
Adım 2
Use an opening tool to pry under the left edge of the home button cable connector to disconnect it from its socket. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.
Disconnect the Touch ID sensor
  • Use an opening tool to pry under the left edge of the home button cable connector to disconnect it from its socket.

  • If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.

開口ツールを使用して、ホームボタンケーブルのソケットからホームボタンケーブルコネクターの左側先端を持ち上げて接続を外します。

もし別々ではなくコネクター全体が持ち上がる場合は、スパッジャーの平面側先端でコネクターのケーブルを押し下げながら、同時にコネクターの左側先端を持ち上げます。ケーブルやコネクターにダメージを与えないよう注意してください。センサーが永久に使えなくなります。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.