Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 5 kılavuzları etkileyecektir.

İngilizce
Flemenkçe
Adım 2
Use an opening tool to pry under the left edge of the home button cable connector to disconnect it from its socket. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor. If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.
Disconnect the Touch ID sensor
  • Use an opening tool to pry under the left edge of the home button cable connector to disconnect it from its socket.

  • If the entire connector begins to flip up without separating, press down on the cable at the top edge of the connector with the flat end of your spudger, while simultaneously prying up the left edge of the connector. Be very careful not to damage the cable or connector, or you will permanently disable the sensor.

Gebruik een openingstool om deze onder de linkerkant van de kabelaansluiting van de thuisknop te duwen en deze zo uit het contact omhoog te duwen.

Als de gehele connector omhoog komt zonder los te laten, zet dan, met het platte einde van je spudger, druk op de bovenkant van de kabel, terwijl je de aansluiting via de linkerkant omhoog probeert te duwen. Zorg dat je de kabel of aansluiting niet beschadigt, aangezien je dan riskeert de sensor permanent te beschadigen.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.