Ana içeriğe geç

Reemplazo del cristal trasero del Samsung Galaxy S7 Edge

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 4 kılavuzları etkileyecektir.

İngilizce
İspanyolca
Adım 2
Samsung Galaxy S7 Edge Rear Glass Replacement: adım 0, 1 resimden 1.
  • Once the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.

  • The suction cup will not adhere well on the curved portion of the glass.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift on the suction cup and insert an opening pick under the rear glass.

  • Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

Una vez que el panel esté lo suficientemente caliente al tacto, coloca una ventosa lo más cerca posible del borde calentado, evitando la parte curvada.

La ventosa no aplica una buena sujeción en la parte curvada del cristal.

Si la tapa trasera del teléfono está rasgada, la ventosa no podrá adherirse. Intenta levantarla con una cinta resistente o pega con adhesivo instantáneo la ventosa y permite que se pega así puedes proceder.

Levanta de la ventosa e inserta un spudger Haldberd o púa de apertura debajo del cristal trasero.

Debido a la curva del cristal, deberás tirar hacia arriba con la ventosa e introducir la herramienta plástica de forma paralela al plano del teléfono.

Si tienes problemas, aplica más calor para ablandar más el adhesivo e intenta nuevamente. El adhesivo se enfría muy rápido, así que quizá deberás calentarlo repetidamente.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.