Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 9 kılavuzları etkileyecektir.

İngilizce
Çince

Adım 10 çevriliyor

Adım 10
Remove the following screws securing the logic board to the rear case:
  • Remove the following screws securing the logic board to the rear case:

  • Two 2.3 mm Phillips screws

  • Two 2.7 mm standoff screws

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  • One non-magnetic 2.7 mm standoff screw

  • Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

松开把主板固定在后盖上的螺丝:

2颗2.3mm飞利浦螺丝

2颗2.7mm中板螺丝

你可以通过专用的压铆螺柱螺丝刀或螺丝刀组更轻松地卸下它们。

简单说来,一个小的平头螺丝刀可以做到——但是需要额外的小心,来保证不损坏周围的部件。

1颗无帽2.7mm 压铆螺柱螺丝

确保把这颗螺丝拧在主板的顶部,带磁性的螺丝会影响数字罗盘。

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Two 2.7 mm standoff screws
- [* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true].
+ [* icon_note] Standoff screws are best removed using a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* yellow] One non-magnetic 2.7 mm standoff screw
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.