Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

İngilizce
İspanyolca

Adım 1 çevriliyor

Adım 1
There is a stretch-release adhesive tab between the battery and the motherboard, use tweezers to pull them from the gap before you begin pulling. Peel out the adhesive strip by steadily pulling at the tab in a flat angle. If the adhesive strip breaks, you can grab and twist it around a tweezers tip a couple of times and continue to pull.
  • There is a stretch-release adhesive tab between the battery and the motherboard, use tweezers to pull them from the gap before you begin pulling.

  • Peel out the adhesive strip by steadily pulling at the tab in a flat angle.

  • If the adhesive strip breaks, you can grab and twist it around a tweezers tip a couple of times and continue to pull.

  • Follow the heating instructions and place an iOpener over the battery to soften the remaining adhesive strip.

Hay una lengüeta adhesiva de liberación por estiramiento entre la batería y la placa madre. Usa pinzas para sacarlas del espacio antes de comenzar a tirar.

Despega la tira adhesiva tirando constantemente de la pestaña en un ángulo plano

Si se rompe la tira adhesiva, puedes agarrarla y torcerla alrededor de la punta de las pinzas un par de veces y continuar tirando.

Sigue las instrucciones de calentamiento y coloca un iOpener sobre la batería para suavizar la tira adhesiva restante.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.