Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 11 kılavuzları etkileyecektir.

İngilizce
İtalyanca
Adım 5
Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board. To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery. Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.
  • Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.

  • To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery.

  • Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.

  • Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try using a playing card to disconnect the battery instead.

  • The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at a 15 degree angle.

  • Leave the battery blocker in place as you work.

Svita la vite a croce Phillips #000 da 2,3 mm che fissa il connettore della batteria alla scheda madre.

Per ridurre il rischio di un corto circuito, puoi usare un blocco per batterie per scollegare la batteria.

Stai molto attento mentre isoli la batteria con un blocco per batterie. I contatti della batteria si danneggiano facilmente, causando danni irreparabili.

Infila il blocco per batterie sotto la scheda madre nella zona del connettore della batteria e lascialo infilato mentre prosegui.

[* red] Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.
[* icon_note] To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery.
-[* icon_caution] Be very careful when you isolate the battery using a battery blocker. The battery contacts are easily damaged, resulting in irreversible damage.
- [* black] Slide a battery isolation pick underneath the battery connector area of the logic board, and leave it in place while you work.
+[* black] Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.
+ [* icon_note] Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try [guide|143682|using a playing card|new_window=true] to disconnect the battery instead.
+ [* icon_note] The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at a 15 degree angle.
+[* black] Leave the battery blocker in place as you work.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.