Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 2 kılavuzları etkileyecektir.

İngilizce
Fransızca
Adım 3
Pull off the black rubber stopper from your bottle of adhesive remover. Twist to loosen or remove the bottle cap before you cut the applicator tip. This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.
  • Pull off the black rubber stopper from your bottle of adhesive remover.

  • Twist to loosen or remove the bottle cap before you cut the applicator tip.

  • This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.

  • Use scissors to cut off the sealed tip of the applicator.

  • Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts.

  • Twist and close the bottle cap securely before you proceed further.

Enlevez le capuchon en caoutchouc du flacon de dissolvant pour adhésif.

Dévissez légèrement ou enlevez le bouchon transparent du flacon avant de couper la tige d'application.

Ouvrir légèrement le flacon permet d'équilibrer la pression avant de couper la tige d'application. Si vous ne le faites pas, il est possible que du dissolvant gicle de manière non contrôlée lorsque vous couperez la tige d'application.

Utilisez des ciseaux pour couper le bout de la tige d'application.

Coupez près de la pointe de la tige d'application, cela vous permettra de mieux contrôler la quantité de dissolvant lors de l'application.

Revissez et refermez bien la bouteille avant de continuer.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.