Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 5 kılavuzları etkileyecektir.
-
Use the flat end of a spudger (or an opening tool) to pry the touch screen cable connector up off the upper logic board.
-
Now that the front panel is out, check it for damage. If the plastic surround is not flush with the front face of the glass panel, gently peel it off and stick it down.
-
Be careful not to scratch the front panel on the underside of the black portions, as the scratches will be visible once the device is reassembled.
-
Be sure to clean both the face of the display and the inner surface of the front panel, as any dust or fingerprints will be trapped inside the Touch once it is fully reassembled.
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.
Kılavuz Adımlarını Düzenlemek için Klavye Kısayolları:
Ctrl + N
Bir sonraki satır
Ctrl + P
Bir önceki satır
Ctrl + Shift + N
Aşağıya yeni bir satır ekle
Ctrl + Shift + P
Yukarıya yeni bir satır ekle
Ctrl + ]
Mevcut satırı girintili yap
Ctrl + [
Mevcut satır girintisini kaldır
Ctrl + D
Mevcut satırı sil
Shift + ;
Sonraki adıma git.
Shift + H
Önceki adıma git.
Bütün kısayolları göster