Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

İngilizce
Fransızca

Adım 1 çevriliyor

Adım 1
Use scissors to cut one of your opening picks to about the width of the battery. Try not to leave any sharp corners. Insert the modified pick between the edge of the battery and the case, on the side opposite the digital crown. Use constant, steady pressure to slowly pry the battery up, separating it from the adhesive securing it to the system board.
  • Use scissors to cut one of your opening picks to about the width of the battery. Try not to leave any sharp corners.

  • Insert the modified pick between the edge of the battery and the case, on the side opposite the digital crown.

  • Use constant, steady pressure to slowly pry the battery up, separating it from the adhesive securing it to the system board.

  • If needed, you can also safely pry along the top edge of the battery, against the Taptic Engine.

  • Mind the display cables so you don't damage them when levering the battery out.

  • Make sure you don't puncture or deform the battery, as it can catch fire and/or explode if damaged.

Avec des ciseaux, taillez un des médiators à la taille de la batterie. Veillez à arrondir les angles.

Insérez le médiator découpé entre le bord de la batterie et la coque, du côté opposé á la couronne digitale.

Soulevez la batterie lentement mais constamment pour la décoller de l'adhésif qui la fixe à la carte mère.

Si nécessaire, faites levier le long du bord supérieur de la batterie, en prenant appui sur le Taptic Engine.

Évitez les nappes de l'écran, de façon à ne pas les endommager quand vous faites levier.

Veillez à ne pas perforer ou déformer la batterie, sinon elle risque de prendre feu et/ou d'exploser.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.