Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 2 kılavuzları etkileyecektir.
Adım 2 çevriliyor
-
Identify and remove the internal battery.
-
The internal battery is held in by up to three screws, circled in red in the photo.
-
If there is no internal battery then remove the spacer shown in the second photo. This is held in by one screw.
-
Remove the internal HDD or SDD.
-
This is held in a carrier tray which is attached to the frame by a single screw circled in orange.
-
The data connection to the motherboard has a silver shield which is held in place by a single screw, circled in yellow in the photo.
-
Set the HDD and internal battery aside.
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.