Ana içeriğe geç
İngilizce
Japonca
Adım 6
Now that your controller looks something like pic 1, open the midframe Partially. Again, be careful here, because the vibration motors are hard-soldered on the board. Remove the two more latches on the sides of the contact pins.
Removing the button board- part 2
  • Now that your controller looks something like pic 1, open the midframe Partially.

  • Again, be careful here, because the vibration motors are hard-soldered on the board.

  • Remove the two more latches on the sides of the contact pins.

  • Pull the board out carefully.

ここでコントローラの外観は写真1のようになります。ミッドフレームの一部を開けます。

ここでも、バイブレータのモーターが基板にしっかりとはんだ付けされているため、慎重に作業を行ってください。

コンタクトピンの両側にある2か所の突起を外します。

基板を慎重に取り外します。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.