Ana içeriğe geç
İngilizce
Çince

Adım 1 çevriliyor

Adım 1
Remove the two pentalobe screws at the bottom edge of the phone. Heat with the Hot Air Gun along edges of the screen evenly for 1 minute to soften up the waterproof seals.
iPhone 11 Pro Teardown
  • Remove the two pentalobe screws at the bottom edge of the phone. Heat with the Hot Air Gun along edges of the screen evenly for 1 minute to soften up the waterproof seals.

  • Press the suction cup firmly onto the screen. Hold the phone with one hand and pull the ring-pull of the suction cup with the other hand.

  • When the screen is lifted, there should be a tiny gap. Insert a plastic pry piece into the gap to get it stuck in the middle. Insert a new pry piece into the gap and slide along edges of the screen to free the screen from the rear housing.

  • Tips: the pry piece shouldn’t go too deep inside and we should swing the screen up from the left side. Otherwise, flex cables on the screen might be damaged

先用五角螺丝刀拆下这两个尾部螺丝。接着用热风枪沿着屏幕边缘来回均匀加热1分钟左右软化防水胶

按压吸盘使其吸住屏幕。一手抓住手机,一手拉紧吸盘拉环

当屏幕和后壳总成之间出现缝隙时,将塑料翘片插入到缝隙处。另外拿一个塑料翘片沿着缝隙滑动,将屏幕和后壳总成分离开来。

注意:翘片不要插入过深。且要从左侧面慢慢掀起屏幕,以免损坏屏幕排线

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.