Eşyalarını Tamir Et Topluluk Mağaza

MacBook Pro 13" Touch Bar 2018 배터리 교체

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 2 kılavuzları etkileyecektir.

Önceki adım

Adım 22 çevriliyor

Kılavuza Dön
İngilizce
Korece
Adım 22
MacBook Pro 13" Touch Bar 2018 Battery Replacement, Battery installation: adım 0, 3 resimden 1. MacBook Pro 13" Touch Bar 2018 Battery Replacement, Battery installation: adım 0, 3 resimden 2. MacBook Pro 13" Touch Bar 2018 Battery Replacement, Battery installation: adım 0, 3 resimden 3.
Battery installation

  • Double-check the fit and alignment of your new battery before sticking it down.

  • Be mindful of the battery data cable and make sure it doesn't get pinched or trapped under the battery board.

  • If your battery came with adhesive pre-installed on the bottom, flip it over and carefully peel away the liner to expose the adhesive. If your battery did not come with adhesive, apply a thin double-sided adhesive tape such as Tesa 61395 to keep your battery in place.

  • Carefully position the battery and set it into place.

  • Place the battery close to the logic board so the trackpad cable can reach its connector.

  • Press and hold each cell firmly for 5-10 seconds to secure it to the lower case.

배터리 설치

새 배터리를 꽂기 전에 새 배터리의 맞춤과 정렬을 다시-확인하세요.

배터리 데이터 케이블을 유의하여 배터리 보드 아래에 집히거나 갇히지 않도록 하세요.

배터리 밑바닥에 접착제가 사전-설치된 경우, 뒤집어서 조심히 라이너를 벗겨 접착제를 드러내세요. 배터리가 접착제를 포함하지 않은 경우, Tesa 61395와 같은 얇은 양면 접착 테이프를 사용하여 배터리를 제자리에 고정하세요.

배터리를 조심히 배치하고 제자리에 맞추세요.

각 셀을 5-10초 동안 길게 눌러 하단 케이스에 고정하세요.

[title] Battery installation
[* icon_reminder] Double-check the fit and alignment of your new battery before sticking it down.
[* black] Be mindful of the battery data cable and make sure it doesn't get pinched or trapped under the battery board.
[* black] If your battery came with adhesive pre-installed on the bottom, flip it over and carefully peel away the liner to expose the adhesive. If your battery did not come with adhesive, apply a thin double-sided adhesive tape such as [product|IF317-072-4|Tesa 61395|new_window=true] to keep your battery in place.
[* black] Carefully position the battery and set it into place.
+ [* icon_note] Place the battery close to the logic board so the trackpad cable can reach its connector.
[* black] Press and hold each cell firmly for 5-10 seconds to secure it to the lower case.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.