Eşyalarını Tamir Et Topluluk Mağaza

MacBook Pro 13" Touch Bar 2018 Vervanging van de antennekabelmodule

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 3 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
Flemenkçe
Adım 7
MacBook Pro 13" Touch Bar 2018 Antenna Cable Assembly Replacement, Disconnect the antenna cables: adım 0, 3 resimden 1. MacBook Pro 13" Touch Bar 2018 Antenna Cable Assembly Replacement, Disconnect the antenna cables: adım 0, 3 resimden 2. MacBook Pro 13" Touch Bar 2018 Antenna Cable Assembly Replacement, Disconnect the antenna cables: adım 0, 3 resimden 3.
Disconnect the antenna cables

  • Carefully disconnect the three antenna coax cables by prying them straight up from the logic board.

  • Slide your tweezers or the pointed end of your spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.

  • To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Koppel de antennekabels los

Koppel de drie antenna-coaxkabels voorzichtig los door deze in een rechte beweging uit het contact op het logic board omhoog te duwen.

Schuif je pincet of het puntige einde van je spudger onder iedere kabel totdat deze bijna bij het contact is, en draai je tool dan voorzichtig om of duw deze omhoog om de kabels los te koppelen.

Om iedere kabel weer aan te sluiten, positioneer je de aansluiting direct over het contact om deze vervolgens naar beneden te drukken totdat deze op z'n plaats klikt.

[title] Disconnect the antenna cables
-[* black] Carefully disconnect the three antenna coax cables by prying them ***straight up*** from the logic board.
+[* black] Carefully disconnect the three [guide|143265|antenna coax cables|stepid=289322|new_window=true] by prying them ***straight up*** from the logic board.
[* icon_note] Slide your tweezers or the pointed end of your spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.
[* icon_reminder] To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.