Ana içeriğe geç

Sostituzione strisce adesive iMac Intel 27" 2012-2019

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 4 kılavuzları etkileyecektir.

İngilizce
İtalyanca

Adım 14 çevriliyor

Adım 14
iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 1. iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 2. iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 3.
  • The microphone hole is the center hole flanked by two larger holes. In the subsequent steps, be sure to align to the microphone hole and not the larger holes.

  • Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

  • If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

  • The adhesive tears easily. Be careful not to pull on the strip with too much force.

  • Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Il foro del microfono è quello centrale affiancato da altri due fori più grandi. Nei passaggi successivi, assicurati di allinearti al foro del microfono e non ai fori più grandi.

Allinea la striscia al bordo inferiore posizionando la rientranza nella striscia con il foro del microfono.

Se il tuo iMac non ha un foro per il microfono, allinea l'estremità destra della striscia in modo che la curva a L sia accanto alla striscia verticale sula lato destro. La curva a L non deve sovrapporsi alla striscia adesiva verticale sul lato destro.

L'adesivo si strappa facilmente. Stai attento a non tirare la striscia con troppa forza.

Una volta allineata la striscia, incolla attentamente l'adesivo esposto alla cornice per assicurarne l'allineamento.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.