Eşyalarını Tamir Et Topluluk Mağaza

iMac Intel 27" 2012-2019 Vervanging van de kleefstrips

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 4 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
Flemenkçe
Önceki adım Sonraki adım

Adım 14 çevriliyor

Adım 14
iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 1. iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 2. iMac Intel 27" 2012-2019 Adhesive Strips Replacement: adım 0, 3 resimden 3.

  • The microphone hole is the center hole flanked by two larger holes. In the subsequent steps, be sure to align to the microphone hole and not the larger holes.

  • Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

  • If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

  • The adhesive tears easily. Be careful not to pull on the strip with too much force.

  • Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Het middelste gat dat tussen twee andere gaten zit, is de microfoon.

Breng de kleefstrips aan de onderkant in de juiste positie door de inkeping voor de microfoon precies om de microfoon heen te leggen.

Als je iMac geen microfoongat heeft, plaats je de L-vormige hoek van de strip precies naast de strip die verticaal langs de rechterzijkant loopt. De L-vormige hoek mag niet met de strip aan de rechterzijkant overlappen.

De kleefstrips is makkelijk te scheuren, dus wees voorzichtig bij het trekken aan de strip.

Als je de strip eenmaal op de juiste positie hebt gebracht, druk je ook de linkerzijde aan.

-[* icon_note] The microphone hole is [https://d3nevzfk7ii3be.cloudfront.net/igi/NZgoACQ4lS2VM2Gi.full|the center hole|new_window=true] flanked by two larger holes.
+[* icon_note] The microphone hole is [https://d3nevzfk7ii3be.cloudfront.net/igi/NZgoACQ4lS2VM2Gi.full|the center hole|new_window=true] flanked by two larger holes. ***In the subsequent steps, be sure to align to the microphone hole and not the larger holes. ***
[* red] Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.
[* black] If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend [https://d3nevzfk7ii3be.cloudfront.net/igi/42luQihIZrU1P3AH.full|sits next to the right vertical adhesive|new_window=true].*** The L-bend should not overlap the right vertical adhesive. ***
[* icon_note] The adhesive tears easily. Be careful not to pull on the strip with too much force.
[* black] Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.