Ana içeriğe geç

iMac 27インチ 2017 ディスプレイアセンブリの交換

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 7 kılavuzları etkileyecektir.

İngilizce
Japonca

Adım 23 çevriliyor

Adım 23
iMac 27" 2017 Display Assembly Replacement, Remove the display: adım 0, 3 resimden 1. iMac 27" 2017 Display Assembly Replacement, Remove the display: adım 0, 3 resimden 2. iMac 27" 2017 Display Assembly Replacement, Remove the display: adım 0, 3 resimden 3.
Remove the display
  • Be very careful handling the display—it's big, heavy, and made of glass. The display has fragile edges. Avoid lifting the display by the corners.

  • Lift the display up from the frame and remove it from the iMac. Lay the display face down on a flat, soft surface.

  • It may be necessary to slowly lift from one side, to peel against the remaining adhesive.

  • After the adhesive is cut, it cannot be used to re-seal the display in place. Follow this guide when your repair is complete to replace the adhesive strips that secure the display to the rear enclosure.

ディスプレイの取り扱いにはご注意ください。ディスプレイは大きくて重量のあるガラスです。 ディスプレイには壊れやすいエッジがあります。 エッジでディスプレイを持ち上げないでください。

ディスプレイをフレームから持ち上げ、iMacから取り外します。 ディスプレイの表面を平らで柔らかい表面上に置きます。

あるいは片側ずつゆっくり持ち上げて、残りの接着剤を剥がす場合があります。

接着剤を切断したら、ディスプレイを装着するために再利用することができません。修理が完了後、このガイドに従って 、ディスプレイをリアエンクロージャーに固定している接着ストリップを交換してください。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.