Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 15 kılavuzları etkileyecektir.

İngilizce
Japonca
Adım 5
Apply a suction cup to the back of the phone, as close to the center of the left edge as possible. Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame. Insert the point of an opening pick into the gap.
Separate the left edge adhesive
  • Apply a suction cup to the back of the phone, as close to the center of the left edge as possible.

  • Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.

  • Insert the point of an opening pick into the gap.

  • As the glass on this edge is curved, you won't be able to insert this pick very far. As long as the very tip of the pick is underneath the glass's edge, you will be able to proceed.

  • Due to tight tolerances, this may take multiple attempts.

  • If you are having trouble creating a gap, apply more heat to the edge and try again.

  • You can try also applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.

  • Do not apply excessive force with the pick, or you risk cracking the back cover glass.

吸盤カップをデバイス背面に装着します。できる限り左端の中央に取り付けてください。

強く、一定の力で吸盤カップを引き上げて、バックカバーとフレームの間に隙間を生じます。

開口ピックの先端を隙間に差し込みます。

このエッジのガラスは湾曲しているため、開口ピックの先端を深くまで差し込むことができません。ピックの先端がガラスエッジの下にある限り、作業を続けることができます。

接着剤の強度のため、この作業は複数回に渡って行う必要があります。

隙間ができない場合は、さらにiOpenerを温めてさらに同じ部分に当ててください。

もしくは高濃度(90%以上)イソプロピルアルコールの数滴を隙間に注入し、接着剤を緩めることもできます。

開口ピックで過剰な力を加えないでください。バックカバーのガラスがひび割れてしまうリスクがあります。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.