Ana içeriğe geç

Google Pixel 4a 스크린 교체하기

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 11 kılavuzları etkileyecektir.

Adım 1 çevriliyor

İngilizce
Korece
Adım 1
Google Pixel 4a Screen Replacement, Precautionary notes: adım 0, 3 resimden 1. Google Pixel 4a Screen Replacement, Precautionary notes: adım 0, 3 resimden 2. Google Pixel 4a Screen Replacement, Precautionary notes: adım 0, 3 resimden 3.
Precautionary notes
  • You will need to pry the screen up to remove it from the phone. Read the following notes carefully before proceeding.

  • Take note of the two seams on the edge of the phone:

  • Screen seam: This seam separates the screen from the rest of the phone. This is where you should pry.

  • Frame seam: This is where the plastic frame meets the back cover. It is held in place by screws. Do not pry at this seam.

  • Before you begin, note the following areas on the screen:

  • Screen flex cable: Do not insert the opening pick deeper than instructed or you risk damaging this cable.

  • Note the orange ribbon cable under the lower-right corner of the screen, which is susceptible to damage if your opening pick is pressed into it. Only insert your opening pick as little as is necessary to separate the screen adhesive.

  • Adhesive perimeter: Prying beyond this narrow perimeter without angling the pick will damage the OLED panel.

휴대폰에서 스크린을 분리하려면 스크린을 비집어야 합니다. 진행하기 전에 다음 주의 사항을 주의 깊게 읽어주세요.

휴대폰 가장자리에 있는 두 개의 이음새에 주목하세요:

스크린 이음새: 이 이음새는 스크린을 휴대폰의 나머지 부분과 분리합니다. 이 부분을 비집어야 합니다.

프레임 이음새: 플라스틱 프레임과 후면 커버가 만나는 지점입니다. 나사로 고정되어 있습니다. 이 이음새는 비집지 마세요.

시작하기 전에 스크린의 다음 영역을 확인하세요:

스크린 플렉스 케이블: 지침보다 더 깊게 끼우지 마세요 이 케이블을 손상할 수 있습니다.

스크린 오른편 하단 모서리 밑에 있는 주황색 리본 케이블은 여는 픽으로 누르면 손상할 수 있으므로 주의하세요. 스크린 접착제를 분리하는 데 필요한 만큼만 여는 픽을 끼우세요.

접착제 경계: 픽의 각도를 기울이지 않고 이 좁은 경계를 지나 비집으면 OLED 패널이 손상될 수 있습니다.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.